4-16CAMSHAFTS ENGNOTE:6. Check: TDC mark aMake sure that the TDC mark is aligned withthe crankcase mating surface b . camshaft sprocket timing mark cMake sure that the camshaft sprocket timingmark is aligned with the cylinder head edgedOut of alignment Adjust.Refer to the installation steps above.7. Measure: valve clearanceOut of specification Adjust.Refer to “ADJUSTING THE VALVE CLEAR-ANCE” in chapter 3.8. Install: cylinder head cover gasket cylinder head cover Apply bond TB1541 onto the mating surfacesof the cylinder head cover and cylinder headcover gasket. Apply bond 1215B onto the mating surfaces ofthe cylinder head cover gasket and cylinderhead. Tighten the cylinder head cover bolts in stagesand in a crisscross pattern.
