6-10CARBURETORS CARBNOTE:NOTE:7 Nm (0.7 mkg)NOTE:NOTE:3. Install: pipes fuel feed pipes vacuum chamber pipe vacuum chamber air vent hose springs float chamber air vent hoses hose joint spacers copper washer connecting bolts Do not tighten the connecting bolts yet. Install the throttle valve lever 1 onto carbure-tors #2, #3, and #4 between the spring 2 andsynchronizing screw 3 .4. Install: starter plunger link 1Install the starter plunger link 1 onto each start-er plunger.5. Tighten: connecting bolts Place the carburetor assembly on a surfaceplate with the intake manifold side down.Then, tighten the connecting bolts while push-ing down the carburetor assembly with aneven force. After tightening the connecting bolts, checkthat the throttle valve lever and starter plungerlink operate smoothly.6. Install: starter cable 1Install the starter cable holder 2 onto the start-er cable.
