INSTRUMENT DESCRIPTIONCarl Zeiss Operation and Functional Elements on the Microscope Axio Vert.A126 431030-7044-001 05/20122.5 Operation and Functional Elements on the Microscope2.5.1 Axio Vert.A1 Stand for Transmitted LightLegend to Fig. 2-6:1 Eyepieces2 Binocular part of the tube3 Transmitted light illumination (either with a halogen or an LED illuminator)4 Two-position filter slider mounted on the carrier for transmitted light illumination5 Condenser (either condensers with modulator disk or condensers with slider slot)6 232 mm x 230 mm specimen stage7 Focusing drive - fine focusing (right-hand side)8 Focusing drive - coarse focusing (right-hand side)9 Illumination intensity of transmitted light on/off- Turn the control button to increase or lower illumination intensity.- Press the control button to switch transmitted light illumination on or off.10 permanent/ECO switch:- permanent position: Transmitted light illumination is switched on permanently, withthe ECO power-saving function not activated.- ECO position: The ECO power-saving function is activated.11 Power indicator (blue)12 Slot for contrast sliders with analyzer or with PlasDIC module (left-hand and right-hand sides)13 Slot for DIC sliders or PlasDIC sliders in the objective nosepiece14 Knurled ring of the objective nosepiece15 Stop for the vertical adjusting range of the focusing drive16 Focusing drive - coarse focusing (left-hand side)17 Focusing drive - fine focusing (left-hand side)18 On / Off switch19 Slot for contrast sliders with analyzer or with PlasDIC module (left-hand and right-hand sides)