PUTTING THE INSTRUMENT INTO OPERATIONAxio Vert.A1 Mounting Standard Components Carl Zeiss05/2012 431030-7044-001 493.1.9 Equipping the Reflector TurretThe reflector turret is fixed-mounted in the Axio Vert.A1 FL, Axio Vert.A1 FL-LED and Axio Vert.A1 MATstands.Fig. 3-12 Equipping the Reflector Turret• Pull the protective cover (Fig. 3-12/5) off to the right.• In the desired order, insert reflector modules, fitted with filter sets (Fig. 3-12/3), into the relevantreflector turret position (see position marking in Fig. 3-12/6), starting at position 1 (emission filter inbottom position). For this purpose, first insert the reflector module in an inclined position from below,with the locating elements (Fig. 3-12/4) on the right-hand and left-hand sides, into the two upperclamping springs (Fig. 3-12/1). Then press the module against the lower clamping springs (Fig. 3-12/2)from the front until the module is safely locked in place.While inserting the module, make certain that it does not get jammed and that you press itsecurely against the upper stop.• To remove a reflector module that is no longer needed, first pull the module out of the lower springclamps and then out of the upper spring clamps.• Plug on the protective cover.• Stick the adhesive labels specifying the filter combinations utilized for each reflector turret position tothe spaces provided on the protective cover.For the insertion and changing of filter sets or beam splitters, see Section 3.3.3 and 3.3.4,respectively.
