OPERATIONAxio Vert.A1 Light Manager Function on the Axio Vert.A1 MAT Stand Carl Zeiss05/2012 431030-7044-001 754.9 Light Manager Function on the Axio Vert.A1 MAT StandThe light manager function can be employed both in reflected light (using the VIS-LED attachment lamp)and transmitted light (using the HAL illuminator or the LED illuminator for transmitted light, provided theoptional carrier for transmitted light illumination is installed).When the HAL 100 is used in reflected light, the light manager is not active, as the HAL 100is powered by an external power supply unit.The light manager performs the following functions:− When the LM Set button is pressed, the current brightness value of the objective used is permanentlysaved. In other words, the last value stored via the LM Set button will be set again even when youswitch the microscope off and turn it on again later.− Separate values are saved for reflected light and transmitted light.− The TL/RL switch is in the RL position for reflected light:A brightness value will be saved for every nosepiece position.− The TL/RL switch is in the TL position for transmitted light:A brightness value will be saved for every nosepiece position.− Dazzle protect function during objective changes.The lamp voltage is factory-set to 3 V for every objective position.4.10 USB Interface on the Axio Vert.A1 MAT StandThe following functions can be used when you connect a PC via the USB interface and install theAxioVision and ZEN (blue edition) software on your PC.− Read nosepiece position (positions 1 to 5 of the coded nosepiece).− Set brightness.− Turn light manager, including dazzle protection, on and off.− Recognize reflected light and transmitted lightRequirements:− MTB 1.8.1.6 (AxioVision)− MTB 2.0.0.12 (ZEN (blue edition))