PYRO A/V LINK 131ENGLISHFCC InformationFederal communications Commission Radio Frequency Interference StatementNote: This equipment has been tested and found to comply with the limits for a class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference when the equipment is operated in a residential installation. This equipment generates, uses andcan radiate radio frequency energy and if not installed and used in accordance with the instruction manualmay cause harmful interference to radio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:* Reorient or relocate the receiving antenna.* Increase the separation between the equipment and receiver.* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.* Consult the dealer or an experienced radio TV technician for help.Notice:(1) The changes or modifications not expressly approved by the party responsible for compliance could voidthe user’s authority to operate the equipment.(2) Shielded interface cables and AC power cord, if any, must be used in order comply with the emission limits.Contacting Technical SupportADS TechnologiesNorth America Office12627 Hidden Creek WayCerritos, CA, 90703Phone: 562.926.1928Technical Support: 562.926.4338Technical Support Hours: M-F 8am-5pm PSTFax: 562.926.0518European OfficeShannon Industrial EstateShannon Co. Clare, IrelandPhone: +353.61.702042