PYRO A/V LINK 22ENGLISHConnecting for Analog Record andPreview at the same timeYou can preview and record video to a VCR at the same time as long as the VCRallows for audio and video to be passed through it. Check and test your VCRto ensure that has audio and video inputs and outputs and that it allows passthrough of audio and video while recording.1.) Connect a video cable from the RCA or S-VHS OUT jacks on the back ofthe PYRO A/V Link and into the Video In on your VCR.2.) Connect an RCA or S-VHS cable to the Video Out on your VCR to anexternal video input (RCA or S-VHS) on your TV.3.) Connect an audio cable to the Left and Right RCA audio OUT jacks on theback of the PYRO A/V Link to the audio inputs (RCA) on your VCR.4.) Connect an audio cable between the Left and Right RCA OUT on yourVCR to the Audio INPUTS on your TV.5.) Apply Power to the VCR – You may have to change the TV/VCR switch onthe VCR to allow pass through.6.) Apply Power to the TV and switch the TV to accept the external videosource. (Check your TV manual if you are not sure how to do this.)The only non-valid connection configuration for video pass-through would be RCA or S-VideoIn and Component Video out. This is because the component jacks are auto-switching andauto-sensing. If you are bringing analog video in, the Component Jacks switch to inputs, ifyou are exporting video out the Component Jacks switch to video output.
