3-4Adaptec RAID Installation Guidec Follow instructions and respond to prompts as necessary toget to the Adaptec splash screen.d When you see the Adaptec splash screen, click CreateDriver Disk. Then, click the appropriate operating system.e Insert a floppy disk and click OK. The system creates thedriver disk.2 Shut down the system and remove the Adaptec RAIDInstallation CD and the driver floppy disk.3 Install and configure your controller and hard drives accordingto the instructions in Chapter 2.4 Start Windows 2000. Windows launches the Found NewHardware Wizard, which searches for the controller.5 Insert the driver disk you created in Step 1.6 Select the floppy disk as the source and then click Next.7 Click Next in the succeeding two windows that appear andfollow the on-screen instructions to complete the controllerinstallation.Upgrading Windows NT to Windows 2000In this scenario, you already have an Adaptec RAID controllerinstalled in your system. However, because you are upgrading to anew operating system, you need to put the correct driver into thenew operating system. To install the driver1 Create a driver floppy disk using the Adaptec RAID Installation CD.To create the diska Insert the Adaptec RAID Installation CD in your drive.b Boot from the CD. The CD loads a Linux kernel that is usedto manage all of its functions.c Follow instructions and respond to prompts as necessary toget to the Adaptec splash screen.
