3-20Adaptec RAID Installation Guide8 Insert the driver disk you created in Step 1 and run dpt411.bat.This utility copies the necessary files to the C drive.9 Run install.bat from the C drive.10 When asked to select a disk driver select i2opci.nlm. Enter theslot number where the controller is installed and press F10.11 Select Save parameters and load driver.12 Select Yes to select another driver.13 Select bkstrosm.ham. Enter the slot number where thecontroller is installed and press F10.14 Select Save parameters and load driver.15 Install any additional drivers and continue the installation.16 Select Edit startup.ncf. If needed, edit the file so that i2opci.nlmis listed before bkstrosm.ham in your startup.ncf file.17 Continue with the NetWare installation according to theNovell documentation.18 Upgrade your NetWare version to the minimum patch levelspecified by Novell.Installing the Driver in a Existing NetWare 4.11 ServerIn this scenario, you are integrating an Adaptec RAID controller intoan existing NetWare 4.11 server as a secondary controller. To installthe driver1 Upgrade your existing NetWare server to the minimum patchlevel specified by Novell.2 Create a driver floppy disk using the Adaptec RAID Installation CD.To create the diska Insert the Adaptec RAID Installation CD in your drive and ablank floppy disk in the floppy disk drive.b Copy all the files in \packages\netware\4.11\driver to thefloppy disk.c Remove the Adaptec RAID Installation CD and the driverfloppy disk.
