3-21Installing the Driver3 Shutdown the server.4 Install and configure your Adaptec RAID controller as asecondary controller according to the instructions in Chapter 2.Note the slot occupied by the controller; you will need thisinformation later in the install process.5 Start up the server. During restart, press Ctrl+A to start SMOR.Use SMOR to create the RAID. For details, refer to UsingSMOR on page 2-10.6 Start NetWare.7 When the console prompt appears, type load install andpress Enter.8 Select Product Options and press Enter.9 Select Install a Product Not Listed and press Enter.10 Insert the disk you created in Step 2 and install I 2O and BlockStorage support only.11 Accept the defaults for the remaining install options.12 Return to the main install screen and select NCF Options.13 Select Edit startup.ncf. If needed, edit the file so that i2opci.nlmis listed before bkstrosm.ham in your startup.ncf file.14 Shutdown and restart the server.Installing the Driver for a Boot Controller in a NewNetWare 4.2 ServerIn this scenario, you are installing an Adaptec RAID controller as theboot controller in a new NetWare 4.2 server. To install the driver1 Create a driver floppy disk using the Adaptec RAID Installation CD.To create the diska Insert the Adaptec RAID Installation CD in your drive and ablank floppy disk in the floppy disk drive.b Copy all the files in \packages\netware\4.2\driver to the floppydisk.
