Adaptec ASR-2000S Installation Manual

Contents

3-15Installing the Driver14 Open the Device Manager. Look for a PCI Card entry under theOther Devices category. There may be multiple entries if youhave multiple Adaptec RAID controllers installed. There mayalso be an entry called PCI Memory Controller.15 Select PCI Card and then select Update Driver from the Drivertab.Note: If you are not prompted for a PCI card or memorycontroller driver, or if the Device Manager shows PCI Cardwith a yellow exclamation mark in the Other Devices list,you might need a patch for your motherboard chipset torecognize multifunction bridge controllers. Contact yourmotherboard vendor and apply the patch. After the patch isinstalled and the system is restarted, Windows will repeatthe device discovery process. If you are installing theoperating system, go back to Step 14 and continue theprocedure. If you are adding an Adaptec RAID controller toan existing configuration, go to Step 6 on page 3-17 andcontinue the procedure.16 Insert the driver disk you created earlier (refer to page 3-11)and let Windows search for the drivers.17 Windows should identify the PCI card as Adaptec I 2 O RAIDHost Adapter. Select Finish. At this point, you might need toforce Windows to copy the driver from the floppy driveinstead of the CD drive.18 When prompted regarding testing the device ROM, selectCancel.19 Open the Device Manager. If the Other Devices category showsa PCI memory controller, select it, click the Driver tab, andselect Update Driver.20 Let Windows search for the drivers on the disk your createdearlier (refer to page 3-11).21 Windows should now identify the PCI memory controller asAdaptec I 2 O Memory Adapter. Select Finish. At this point, youmight need to force Windows to copy the driver from thefloppy drive instead of the CD drive.