3-7Installing the Driver4 Shut down the system and remove the Adaptec RAIDInstallation CD and the driver floppy disk.5 Insert the Windows NT setup media (floppy disk or CD) andrestart the system.6 If prompted, skip Setup’s mass storage detection. Press S toSpecify Additional Devices.7 Select Other, then insert the driver disk you created in Step 3.8 Select Adaptec I 2O RAID Host Adapter Driver for NT 4.0.9 Press Enter and continue with the installation as described inthe Windows NT documentation.Installing the Driver in a New System with Other HardwareIn this scenario, you are installing an Adaptec RAID controller in anew computer system with another controller from anothermanufacturer or other hardware that requires the use ofWindows NT mass storage detection. To install the driver1 Create a driver disk using the Adaptec RAID Installation CD. Tocreate a driver diska Insert the Adaptec RAID Installation CD in your drive.b Boot from the CD. The CD loads a Linux kernel that is usedto manage all of its functions.c Follow instructions and respond to prompts as necessary toget to the Adaptec splash screen.d When you see the Adaptec splash screen, click CreateDriver Disk. Then, click the appropriate operating system.e Insert a floppy disk and click OK. The system creates thedriver disk.2 Shut down the system and remove the Adaptec RAIDInstallation CD and the driver floppy disk.3 Install and configure your Adaptec RAID controller and harddrives according to the instructions in Chapter 2.
