Workgroup Remote Access Switch 101A PPLE T ALK R OUTING N ETWORKConfigure the CyberSWITCHCONFIGURING DEVICE I NFORMATIONSelect Security from the Main CFGEDIT Menu. The Security Menu will then be displayed asfollows:We need to configure device information for our remote device, SITE2. Remote devices areconfigured in the on-node authentication database.After selecting Device Level Database(s) from the Security menu shown above, the following DeviceLevel Database Menu will be displayed.Select On-node Device Entries from the above menu, then select to add a device. Enter SITE2 as thedevice name. The following screen will then be displayed.The three areas of information we must configure for device SITE2 are ISDN, Authentication, andAppleTalk. The following sections will help you configure each of these three areas for device SITE2.C ONFIGURING D EVICE SITE2’S ISDN INFORMATIONWe will begin by specifying the type of device. This device is an ISDN device, so we will selectISDN from the Device Table Menu.The ISDN Menu will then be displayed with preconfigured default values as shown below:Security Menu:1) Security Level2) System Options and Information3) Device Level Databases4) User Level Databases (Enable/Disable)5) Off-node Server Information6) Network Login InformationSelect function from above or for previous menu: 1Device Level Database Menu:1) On-node Device Database (Enable/Disable)2) On-node Device Entries3) Off-node Device Database LocationSelect function from above or for previous menu: 1Device Table Menu: (Device = "SITE2")1) ISDN2) Frame Relay3) X.254) Authentication5) IP6) IPX7) AppleTalk8) Bridging9) CompressionSelect function from above or for previous menu: 1