Cabletron Systems Cyber SWITCH 1000 User Manual

EXAMPLE NETWORKS36 CyberSWITCHC ONFIGURE THE C YBER SWITCHNote: The software should have already been installed and you should see the system promptbefore proceeding with these steps.Using the detailed instructions for these steps found in the Simple Remote Bridging chapter,complete the following configuration steps.Start the CFGEDIT programSelect physical resourcesSelect to add a resourceSelect Switch type to be 4ESSSelect to add a lineEnter “Line1” as the line nameSelect slot 1, port 1Add Data LinksChoose Auto TEI NegotiationEnter SPID ValueEnter Directory Number for Data LinkEnter Maximum Number of Digits to VerifyRepeat “Add Data Links” for second Data LinkRepeat “Select to add a line” for each additional lineThe following sections provide instructions for completing the remaining configuration steps.CONFIGURING THE CYBER SWITCH OPTIONSTo begin the configuration of the system options, press 2 at the Main Menu. The following optionsmenu will then be displayed:For this example, we only need IP routing enabled. IP routing is already enabled as fault, so nochange is necessary.For this example, the only other IP information we need to configure is for IP interfaces. No staticroutes are needed because Router 1 supports RIP, which eliminates the need to manually configurea static route. The next section will provide the instructions needed to configure the necessary IPinterfaces.Options Menu:1) Bridging2) IP3) IPX Routing4) AppleTalk5) SNMP6) PPP7) Call Control Options8) Default Line Protocol9) Log Options10) CompressionSelect function from above or for previous menu: