Cabletron Systems Cyber SWITCH 1000 User Manual

Workgroup Remote Access Switch 15SIMPLE R EMOTE B RIDGING N ETWORKBridging and Routing InformationTo configure the IP host interface:1. Select IP Interfaces from the IP configuration menu.2. Select to add an interface.3. Enter the IP address assigned to this interface. For SITE1, this is 192.42.1.6; for SITE2, this is192.42.1.7.4. Enter the subnet mask.5. Enter the MTU size.6. Select the transmit broadcast address.If IP RIP is enabled, enter the following additional information:7. IP RIP receive control.8. IP RIP respond control.9. IP RIP v2 authentication control.10. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has beenconfigured with a value other than “No Authentication.“For more detailed information on the IP host operating mode, refer to the IP Operating Mode sectionin the Configuring Basic IP Routing chapter of the User’s Guide.C ONFIGURING THE S ECURITYFor this network configuration, we require no security. The default configuration is device securityenabled. To make the required configuration change, select Security from the Main Menu. Thenselect Security Level. Finally, select No Security.SAVE CONFIGURATION F ILESWe have now configured all of the required information. Press 4 from the Main menu to save thechanges and then press to exit. Reboot the system to activate your changes.