EXAMPLE NETWORKS86 CyberSWITCHfour calls/connections running in parallel). Configure a dial-out number for the Dallas site, which is:912143339999. We will not use the remaining parameters (subaddress, profile name or HO support)for this example. Return to the Device ISDN menu (following), and then return to the Device TableMenu:Authentication InformationFrom the Device Table Menu, select Authentication. Add the Dallas site’s PAP password, which isdnpswd.IPX InformationFrom the Device Table Menu, select IPX. From this configuration menu, insure that IPX routing andMake calls for IPX data are enabled. You may then enable IPXWAN protocol:Next, select Routing Protocol. For this example, we will use the triggered RIP/SAP protocol, andselect a WAN Peer Type of ACTIVE:Finally, there is no need to change the default Spoofing Options. Return to the Device Table Menu.Device ISDN Menu: (Device = "dallasnet")1) ISDN Line Protocol "PPP (Point to Point Protocol)"2) Base Data Rate "64000 bps"3) Initial Data Rate "64000 bps"4) Maximum Data Rate "256000 bps"5) Dial Out Phone Number(s) "912143339999"6) Subaddress ""7) Profile Name "Default_Profile"8) H0 Call Support DISABLEDSelect function from above or for previous menu:Device IPX Menu: (Device = "dallasnet")1) IPX Routing ENABLED2) Make calls for IPX data ENABLED3) IPXWAN Protocol DISABLED4) Routing Protocol None5) Spoofing OptionsSelect function from above or for previous menu?3Use the IPXWAN protocol for this device (Y or N) [default = N] ?YIPX Device Routing Protocol1) None2) RIP/SAP3) Triggered RIP/SAPEnter selection or press for previous menu [default=None}:31) Active2) PassiveTriggered RIP/SAP WAN Peer type [default=ACTIVE]:1