The pressure gage (C) may read higher than theactual tire pressure while the compressor is on.Turn the compressor off to get an accurate reading.The compressor may be turned on/off until thecorrect pressure is reached.If you inflate the tire higher than the recommendedpressure you can adjust the excess pressure bypressing the pressure deflation button (D) until theproper pressure reading is reached. This optionis only functional when using the air only hose (G).11. Press the on/off button (B) to turn the tire sealantand compressor kit off.Be careful while handling the tire sealant andcompressor kit as it could be warm after usage.12. Unplug the power plug (H) from the accessorypower outlet in the vehicle.13. Disconnect the air only hose (G) from the tire valvestem, by turning it counterclockwise, and replacethe tire valve stem cap.14. Replace the air only hose (G) and the power plug(H) and cord back in its original location.15. Place the equipment in the original storage locationin the vehicle.The tire sealant and compressor kit has an accessoryadapter located in a compartment on the bottom of itshousing that may be used to inflate air mattresses,balls, etc.Removal and Installation of the SealantCanisterTo remove the sealant canister:1. Unwrap the sealant hose.2. Press the canister release button.3. Pull up and remove the canister.4. Replace with a new canister which is available fromyour dealer/retailer.5. Push the new canister into place.5-103
