4-27Chapter 4 Setting Up and Using Speed DiallingHere are some important points you should keep in mind when you use One-touch Speed Dialling:J To start scanning immediately, press START/SCAN. Otherwise the faxwill wait 5 seconds before it starts scanning. This timeout feature can beturned off. (Q16-11)J To locate and press the correct button, you may have to open the One-touch Speed Dialling panels.J The fax will not dial the number registered for the One-touch SpeedDialling button until you set the document on the fax for sending. If youpress the button before you load the document, the fax will prompt you:SET DOCUMENTJ If you press a One-touch Speed Dialling button where no number hasbeen registered, the fax tells you:NO TEL#12J If you want to cancel the transmission after you press a One-touch SpeedDialling button, press STOP. (Q6-8)J When you come to a step in any procedure where you have to dial anumber, you can press a One-touch Speed Dialling button to dial.When you register a number for One-touch Speed Dialling, Coded SpeedDialling and Group Dialling, you can, as an option, set the time you want yourdocument to go out (up to 5 different times in a day). If you are using a speeddial button that was set by someone else, and you would like your document togo out at the preset time, verify if the preset time feature is being used for thatbutton. (Q4-9, 4-17, 4-24, 16-30)
