Note• For details on types of paper to select, see the Paper Reference Guide. (See "Types of Paper.")→P.5798. Holding it at the positions indicated, close the Roll Cover.Note• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissorsor the blade after removing creased edges. (See "Specifying the Cutting Method for Rolls.")→P.602Changing the Type of PaperFollow these steps to change the type of paper specified on the printer after you have loaded paper.If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort ofconfiguring the media type setting when you load the paper again. The current media type settings before you select Onwill be automatically selected at that time. (See "Using the Same Type of Paper Regularly.") →P.593Important• For best printing results, the printer fine-tunes the feed amount for each type of paper. Be sure to selectthe type of paper to use correctly before printing.• Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printedimages may vary depending on the type of paper used. If margins and the size of images are not as youexpected, adjust the paper feed amount.(See "Adjusting the Feed Amount.") →P.628Changing the Type of PaperNote• After you load a roll, the printer automatically shows a menu for selection of the type of paper on theDisplay Screen. Select the type of paper and press the OK button.If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the rolllength after the type of paper. (See "Specifying the Paper Length.") →P.5941. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab ( ).Handling Paper > Handling rolls >Changing the Type of Paper iPF7557592
