6. Press ▲ or ▼ to select IPv4 Settings, and then press the OK button.7. Press ▲ or ▼ to select IP Address, and then press the OK button.8. After you press ◀ or ▶ to select the input field, numerical input is possible.9. Press the ▲ or ▼ button to enter the value.Note• Pressing the ▲ button increases the number by 1. The maximum value is 9, after which 0 is dis-played.• Pressing the ▼ button decreases the number by 1. The minimum value is 0, after which 9 is dis-played.• Hold down ▲ or ▼ to increase or decrease the value continuously.• Make sure the IP address you enter for the printer is not the same as any computer IP address inyour network.10. Repeat steps 8 and 9 to complete the settings, and then press the OK button.11. Press the Menu button.If you have changed the settings, a confirmation message is displayed. Press ▲ or ▼ to select Yes, and thenpress the OK button.Important• Be sure to complete step 11. This will activate the values you have entered.• You can also specify the subnet mask and default gateway on the Control Panel.Note• If an error message is displayed, check the settings and correct any invalid values.Configuring the IP Address Using ARP and PING CommandsThis topic describes how to configure the IP address using ARP and PING commands.Network Setting > Network Setting >iPF755 Configuring the IP Address Using ARP and PING Commands10705
