Note• RemoteUI also offers many other features. You can display the ink levels, check error messages and oth-er status information, and cancel print jobs.• By factory default, the English screen is displayed. To change the display language, select the desiredlanguage under Language before logging on in administrator mode.• If you login in Administrator Mode, you can configure to use the Jumbo Frame function in the Networkpage. However, this function might not be able to be used depending on the network environment.Important• Use Netscape Navigator 6.0 or later, Internet Explorer 5.01 or later, or Firefox 1.5 or later as a webbrowser. In Mac OS X, you can also use Safari 1.32 or later or Safari 2.03 or later.• Access is not possible via a proxy server. In environments where a proxy server is used, add the printer'sIP address to Exceptions (addresses accessed without a proxy server) in the web browser proxy serversettings. (Settings may vary depending on the network environment.)• Enable JavaScript and cookies in the web browser.• If you access RemoteUI with the printer name instead of its IP address, make sure the DNS settings arecorrectly configured.• RemoteUI might not be able to start depending on the network environment.• Check that Use RemoteUI in System Setup is set to On in the printer Control Panel.Configuring the Printer's TCP/IP Network SettingsFollow the steps below to configure the TCP/IP network settings.When using an IPv4 IP address1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the TCP/IPv4 group to display the Edit TCP/IP Protocol Settings page.6. Refer to the TCP/IP Settings Items table to complete the settings.TCP/IP Settings ItemsItem Details Default SettingUse DHCP Activate this setting to use DHCP for configuring the IP ad-dress.OffUse BOOTP Activate this setting to use BOOTP for configuring the IP ad-dress.OffUse RARP Activate this setting to use RARP for configuring the IP ad-dress.OffEnable DNS Dy-namic UpdateActivate this setting to perform DNS server registration auto-matically.OffNetwork Setting > Network Setting >Configuring the Printer's TCP/IP Network Settings iPF75510708
