Cause Corrective ActionThe type of paper as specified onthe printer does not match the typespecified in the printer driver.1. Press the Stop button and stop printing.2. Change the type of paper in the printer driver and try printing again.The paper is wrinkled or warped. Straighten out the wrinkles or curls and reload the paper. Do not use paperthat has been printed on previously.(See "Loading Rolls in the Printer.") →P.588(See "Loading Sheets in the Printer.") →P.609A cut line is printed because Cut-DustReduct. is On in the ControlPanel menu to reduce cutting dust.If this function is not needed, set CutDustReduct. to Off in the Control Pan-el menu.(See "Menu Settings.") →P.667The Printhead is set too low in theControl Panel menu.In the Control Panel menu, set Head Height to Automatic.(See "Troubleshooting Paper Abrasion and Blurry Images (HeadHeight).") →P.626You are printing on heavyweightpaper or paper that curls or wrin-kles easily after absorbing ink.When printing on Heavyweight Coated Paper or other paper-based media,choose a VacuumStrngth setting of Strong or Strongest in the Control Pan-el menu. If the paper still rubs, set Head Height to Highest in the ControlPanel menu.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.635(See "Troubleshooting Paper Abrasion and Blurry Images (HeadHeight).") →P.626When printing on CAD Tracing Paper or other film-based media, choose aVacuumStrngth setting of Standard, Strong, or Strongest in the ControlPanel menu. If the paper still rubs, set Head Height to Highest in the Con-trol Panel menu.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.635(See "Troubleshooting Paper Abrasion and Blurry Images (HeadHeight).") →P.626The Ejection Guide is soiled. Clean the Ejection Guide.(See "Cleaning the Printer Exterior.") →P.757The surface of the paper is dirtyCause Corrective ActionThe Paper Retainer is soiled. Clean the Paper Retainer.(See "Cleaning Inside the Top Cover.") →P.757You are using a paper thatdoes not dry easily.In the Control Panel menu, set Roll DryingTime to at least 1 min.(See "Menu Settings.") →P.667When paper that does not dry easily is used for printing, it may curl during printingand touch the Output Tray.In this case, in the Control Panel menu, complete the settings for Dry time andArea in Scan Wait Time.However, note that printing will now take longer.(See "Menu Settings.") →P.667The back side of the paper is dirtyCause Corrective ActionThe Platen has become dirty after border-less printing or printing on small paper.Open the Top Cover and clean the Platen.(See "Cleaning Inside the Top Cover.") →P.757Troubleshooting > Problems with the printing quality >The surface of the paper is dirty iPF75512784
