3. Press the Cut button.4. Press ▲ or ▼ to select Yes, and then press the OK button.After the roll paper is cut, it is rewound automatically.Caution• If paper would be short when cut at a particular position, the roll may automatically be advancedin some cases before cutting.Cutting the Leading Edge of Roll Paper AutomaticallyIf the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, setTrim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut the leading edgeto make the edge straight after you load a roll.Trim Edge First offers the following options.• AutomaticIf the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more whenyou load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed.The edge is not cut if the unevenness is less than 3 mm. However, paper may sometimes be cut, depending on thestate of the leading edge.• OffThe edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default. For moreinformation, see the Paper Reference Guide. (See "Types of Paper.") →P.579• OnThe leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from the lead-ing edge varies depending on the type of paper. For more information, see the Paper Reference Guide. (See"Types of Paper.") →P.579Handling Paper > Handling rolls >Cutting the Leading Edge of Roll Paper Automatically iPF7557606
