7. Click Yes to exit PCONSOLE.Specifying NetWare ProtocolsFollow the steps below to configure NetWare protocol settings other than the frame type by using RemoteUI.Note• For details on RemoteUI, see "Using RemoteUI." →P.7071. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settingspage.6. Make sure the Frame Type indicates the frame type used on the NetWare network.7. To use burst mode, choose On for NCP Burst Mode.Note• Burst mode supports fast data transfer when printing in queue server mode. Normally, chooseOn.8. In Print Application, click the print service to be used.Note• Only one print service selected here will be enabled. Multiple print services are not available atthe same time.9. For packet signature, click If Requested by Server in Packet Signature.10. Complete the following settings based on the selected service.• If you have selected Bindery PServer: Queue Server Mode (Using a Bindery Print Server)1. In File Server Name, enter the file server name.2. In Print Server Name, enter the name of the print server created in "Specifying NetWare Print Serv-ices →P.720 ."3. In Print Server Password, enter the password of the print server created in "Specifying NetWarePrint Services →P.720 ."4. In Polling Interval, specify the interval at which the printer checks the NetWare print queue.• If you have selected RPrinter: Remote Printer Mode (Using a Bindery Print Server)Network Setting > Network Setting (Windows) >iPF755 Specifying NetWare Protocols10723
