Configure Library MenuThe Configure Library menu contains the following submenu items:v “Configure Library: General”v “Configure Library: Logical Libraries” on page 5-45v “Configure Library: Path Failover” on page 5-46v “Configure Library: Encryption” on page 5-47v “Configure Library: Drives” on page 5-49v “Configure Library: Network” on page 5-50v “Configure Library: User Access” on page 5-52v “Configure Library: Date & Time” on page 5-54v “Configure Library: Logs & Traces” on page 5-54v “Configure Library: Email Notification” on page 5-55v “Configure Library: SNMP” on page 5-56v “Configure Library: Save/Restore Configuration” on page 5-56Configure Library: GeneralThis page allows you to make changes to general library configuration elements.As changes are made, they will only be applied after the Apply Selections or theSubmit button is selected. After making the selection, a warning page will informyou of the impact of the proposed change. In some cases a pop-up screen will askfor confirmation. Many changes will also require a library reboot.Table 5-10. Configure Library: General page elementsMenu Item Description 2U 4ULibrary Name Enter the name of the library. X XI/O StationEnabledThe I/O Station defaults to I/O Station Enabled. Choosing Disabled (nocheckmark) adds one more storage slot to the 2U library, and 3 morestorage slots to the 4U library. When the I/O Station is disabled,removing or adding media to the library must be performed by releasingthe left and/or right magazine(s).X XAuto CleanEnabledAuto Clean defaults to Disabled. For Auto Clean to function, a cleaningcartridge (CLNxxxLx) must be resident in a reserved library slot andAuto Clean must be enabled (turned on).Note: If Auto Clean is enabled, and a cleaning cartridge is not resident ina reserved slot, the Auto Clean Status field in the web System Statusscreen will post a "Chk Media/Rsvd Slot" message.X XBar Code LabelLength ReportedTo HostThe default bar code label length is 8, but can be set to 6. The bar codelabel length is a "reported" length. This setting will cause the hostcomputer to only see the first 6 characters of the label or all 8 characters.This setting does not affect the bar code label that is shown on any of thelibrary user interfaces (always shows all 8 characters).X XTable 5-11. Configure Library: Specific page elementsMenu Item Description 2U 4ULibrary Mode Choices are Random and Sequential. If you choose Sequential, you mayalso activate Autoload and/or Loop. If there is more than one logicallibrary, there is a Library Mode entry for each logical library.Important: If a Logical Library in Sequential Mode contains more thanone drive, only the first drive in the Logical Library will be utilized.X X5-44 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
