For information on running the diagnostic, refer to “Service Library: Key PathDiagnostics” on page 5-61.Restoring Factory Default Settings using the Web User InterfaceIf you would like to erase your current configuration and restore factory defaultsettings, do so by selecting Restore Factory Defaults in the Configure Library →Save/Restore menu. See “Configure Library: Save/Restore Configuration” on page5-56.The factory default settings are listed in Table 5-4 on page 5-28.Logging out of the Web User InterfaceTo log out of the Web User Interface, click Logout in the upper right corner of thecurrent screen.Important: If you click the X in the upper right corner of your internet browserwindow, you will not log out of the Web User Interface.Configuring Your Library using the Operator Control PanelIf you choose to use the Operator Control Panel for configuring your library, go to“Configure Menu” on page 5-18 for information on configuring the followingitems:v Logical Librariesv Library Settingsv Drive(s)v Networkv Set Access PINv Set Date and Timev Path FailoverTo complete the configuration of your library, the following items will have to beaccessed from the Web User Interface:v Encryption (if purchased) (see “Configure Library: Encryption” on page 5-47)v User Access Information (see “Configure Library: User Access” on page 5-52)v Logs and Traces (see “Configure Library: Logs & Traces” on page 5-54)v Event Notification Information (see “Configure Library: Email Notification” onpage 5-55)v Key Path Diagnostic (if Encryption was purchased) (see “Service Library: KeyPath Diagnostics” on page 5-61)v Updating Firmware (see “Service Library: Upgrade Firmware” on page 5-62)Preparing the HostFollow these general guidelines:1. Make sure that your backup application supports the SCSI, SAS, or FibreChannel host bus adapter (HBA).2. If the host server is connected to a network, check with the systemadministrator before turning host power OFF.Chapter 4. Installation and Configuration 4-31
