7. Select Enable SSL for EKM to enable Secure Sockets Layer for the DellEncryption Key Manager application.8. Select an Encryption method, from the pull down menu, for each logicallibrary.v Without an encryption license key, select None or Application ManagedEncryption.v With an encryption license key, select Library Managed Encryption.9. Select an Encryption policy, from the pull down menu, for each logicallibrary.v Encrypt All: This is the default policy. It encrypts all cartridges using thedefault data keys specified in the EKM. This setting applies to all drives inthe TL2000/TL4000 logical library.v Internal Label - Selective Encryption: Check your tape backup softwareapplication documentation to see if this feature is supported.v Internal Label - Encrypt All: Check your tape backup software applicationdocumentation to see if this feature is supported.10. A primary and secondary EKM server can be set for each logical library. Eachpartition has its own Encryption and EKM settings. Maintaining primary andsecondary EKM servers is desired for maximum availability of encryptedbackup and recovery. These settings are required for Library ManagedEncryption only. Enter the EKM Server Setting information.v Primary IP address (IPv4 or IPv6): Enter the IP address of the primaryEKM server.v Primary TCP port: After entering the Primary IP address, the library willautomatically set the value of the Primary TCP port.v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondaryEKM server.a77ug190Figure 5-40. Configure Library: Encryption Feature configuration screen5-48 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide