Configure Library: SNMPThis page shows the current SNMP configuration of the library and allowsmodification to the configuration. When a change is requested, a pop-up boxchecks to confirm the changes.1. Click SNMP in the left navigation pane, to display the SNMP page.2. Enter SNMP settings.Note: For more information on SNMP, refer to “SNMP Messaging” on page 1-7and Appendix F, “SNMP Status MIB Variables and Traps,” on page F-1.a. Enabled - Check this box to have SNMP traps sent to a SNMP Managementconsole(s).b. Target 1-IP Address - If SNMP traps are enabled, enter an IP address whereSNMP traps are to be sent.c. Target 2-IP Address - Enter an optional 2nd IP address where SNMP trapsare to be sent, or leave as 0.0.0.0.d. Target 3-IP Address - Enter an optional 3rd IP address where SNMP trapsare to be sent, or leave as 0.0.0.0.e. Version - The library offers three versions of the SNMP protocol; v1, v2 andv3. Select a version for each Target IP Address.f. Community Name - An SNMP community name is a text string that acts asa password to authenticate messages sent between the SNMP remotemanagement application and the library. Enter your preferred name, or leaveas “public”. The Community Name is limited to 33 alpha-numeric characters(A-Z, a-z, 0-9).3. Click one of the following:v Refresh - to cancel the changes made to the screen.v Submit - to apply the changes made to the screen.Configure Library: Save/Restore ConfigurationThis page allows the library configuration to be reset to the factory defaults.Saving and restoring configuration data can be done using the RemoteManagement Unit (RMU) and/or the Operator Control Panel (OCP). The featurehas been implemented on the RMU and on the OCP, but with slightly differentfunctionality.a77ug257Figure 5-49. Configure Library: SNMP Page5-56 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide