Chapter 4. Installation and ConfigurationNote: Review the information in "Installation Planning" before installing yourlibrary.To install a desktop or rack mounted 2U library or 4U library, perform theprocedures in this chapter in the order they are presented.Using the Library Configuration FormBefore beginning the installation and configuration of your library, make a copy ofthe Appendix G, “Library Configuration Form,” on page G-1. Enter libraryinformation (such as serial numbers, types of drives, etc.) and configurationsettings on the Library Configuration Form and store in a safe location for futurereference. Be sure to update this form any time changes are made to your libraryhardware or configuration.Installing Your LibraryComplete these procedures to install your library hardware.1. “Choosing a Location.”2. “Unpacking the Library” on page 4-2.3. “Verifying the Shipment” on page 4-2.4. “Installing the Library Foot Pads (for Desktop Installation ONLY)” on page 4-3.5. “Removing and Storing the Shipping Lock” on page 4-4.6. “Rackmounting the Library (for Rack Installation ONLY)” on page 4-5.7. “Connecting the Host Interface Cable” on page 4-11.8. “Connecting a Power Cord” on page 4-13.Choosing a LocationChoose a location that meets the following criteria:Table 4-1. Location criteriaCriteria DefinitionRoom temperature 10° - 35° C (50° - 95° F )Note: If the temperature in the room where the library will be installed varies by 15° C (30°F) from the room where the library was stored, allow the library to acclimate to thesurrounding environment for at least 12 hours before unpacking it from the shippingcontainer.Power source v AC power voltage: 100-127 VAC; 200-240 VAC (4 - 2 A)Note: The 4U library requires two separate power sources to implement redundantpower.v Line frequency: 50-60 HzPlace the library near an AC outlet. The AC power cord is the product's main ACdisconnect device and must be easily accessible at all times. Two separate power sourcesmust be available for redundant power.4-1