1 SCSI cable2 SAS cable3 SCSI terminator4 Fibre Channel cable5 Ethernet cable6 Power cords7 Drive sled blue captive thumbscrews8 Black pull-out tab9 Drive sled10 Drive sled handle5. If present, remove the conductive tape from the drive sled (refer to Figure 10-9on page 10-8).6. Loosen the blue captive thumbscrews (7 in Figure 10-6) on the drive sled.7. Pull straight back on the drive sled handle (10) to remove it from the library(see Figure 10-7 on page 10-6).8. If you are replacing the tape drive sled, proceed to Installing a Tape Drive Sledfor instructions. If you are not replacing the tape drive sled immediately, youwill need to perform the following procedures:a. Install a drive cover plate to protect your library from dust and debris.b. To remove the "Missing drive" indicators on the Operator Control Panel(Attention LED) and the Web User Interface (System Status screen), modifyor resubmit logical library setting (Operator Control Panel: Configure →Logical Libraries or Web User Interface: Configure Library → LogicalLibraries).a77ug2041 342 5610789 7Figure 10-6. Drive sled components (full-high fibre drive in top position, half-high SCSI drive in middle position,half-high SAS drive in bottom position) on back panel of a 4U libraryChapter 10. Check, Adjust, Remove, and Replace 10-5
