Entering Email Notification Information using the Web UserInterfaceThis function is not available on the Operator Control Panel.Use this menu item to set up email notification of library errors and warnings.1. Click Configure Library → Email Notification in the left navigation pane.2. If you would like to be notified when an error occurs, select Notify Errors.3. If you would like to be notified when a warning occurs, select NotifyWarnings.4. In To Email Address, enter the email address to which the information will besent.5. In SMTP Server Address (IPv4 or IPv6), enter the IP Address of the SMTPserver associated with the email address.6. Enter the Domain Name for your library. This field cannot be blank whenusing event notification.Note: If you attempt to enter a blank value for the Domain Name, a warningmessage will appear. It will say If you are using Event Notification thena value is required for the Domain Name.7. Click one of the following:v Refresh - to cancel all of your entries and leave the settings as they were.v Submit - to apply the changes made to the screen.Configuring SNMP SettingsThis page shows the current SNMP configuration of the library and allowsmodification to the configuration. When a change is requested, a pop-up boxchecks to confirm the changes.1. Click SNMP in the left navigation pane, to display the SNMP page.a77ug065Figure 4-31. The Configure Library: Email Notification screenChapter 4. Installation and Configuration 4-29
