d. Click Upgrade Firmware.e. Browse to the new firmware level on your host, then click Update. Do thisfor both library and drive firmware, if necessary.4. Install the MIB file on your SNMP server. Refer to your server applicationdocumentation for instructions.Choosing General Library SettingsIf your library contains only one drive or logical library, both general and specificsettings will be combined into one table (see Figure 4-18 on page 4-20).1. Expand Configure Library in the left navigation pane of the Web UserInterface.2. Click General and enter the following:v Library Name - Enter a name for your library.v Library Mode (select one of the following per logical library):– Random: In random mode, the library allows the server's (host's)application software to select any data cartridge in any order.– Sequential: In sequential mode, the library's firmware predefines theselection of the cartridges. After initialization, the firmware causes thelibrary to select the first available cartridge found (counting from the I/OStation through the last slot in your library) for loading into the drive.Important: If a Logical Library in Sequential Mode contains more thanone drive, only the first drive in the Logical Library will beutilized.- Autoload: Sequential mode with autoload mode ON loads the firstavailable cartridge (slot with the lowest numerical value that contains acartridge) automatically if the library powers ON with an empty drive.- Loop: Sequential mode with loop mode ON loads the cartridge in thelowest numerical slot after the cartridge in the highest numerical slothas been filled and sent back to its home slot. This allows endlessbackup operations without user interaction.v Active Slots - Select the number of active slots you would like to assign inyour library. This item will affect the number of Res. (Reserved) Slots inyour library. For more information refer to “Configuring I/O Stations andReserving Slots” on page 5-65.Note: Slots can be reserved so that they are invisible to the host. It may benecessary to reserve slots in order to match the number of availableslots to the ISV software licensing. Slots will be reserved starting withthe highest element address. If your library does not have a dedicatedcleaning cartridge slot, and you desire to enable Auto Clean, you mustdesignate a reserved slot which can be used to hold the cleaningcartridge.v I/O Station Enabled - If checked, the I/O Station is enabled. If not, the first 3slots (in a 4U library or the 1st slot in a 2U library) are configured as storage.See “Configure Library: General” on page 5-44.v Auto Clean Enabled - Automatically cleans drive when drive requestscleaning and cleaning cartridge is present in a reserved slot or a dedicatedcleaning slot. All cleaning cartridges must have CLN as part of the bar code.The Universal Cleaning Cartridge has the bar code label CLNUxxLx.v Bar Code Label Length Reported to Host - Choose between 6 and 8. With 6,the first six characters of the cartridge VOLSER (Volume Serial Numbers)Chapter 4. Installation and Configuration 4-19
