Denon AVR-4520CI Owner's Manual

Also see for AVR-4520CI: Getting started guide Specification Model information Service manual

Contents

163Operating learning functionIf the AV device is not a DENON device, or if the device does notoperate even when the preset code is registered, use the learningfunction. Remote codes for different devices can be remembered foruse by the DENON remote control included with this device.Remembering remote control codes fromother devices1 Press and hold RC SETUP for atleast 3 seconds.“SETUP” and indicator flashes twiceon the remote control unit.2 Use ui to display “LEARN” onthe remote control unit and pressENTER.3 When “DEVIC” appears on theremote control unit, press theinput source select button of theAV equipment that you want tostore.• You cannot store the remote control codein the AVR button.• Before using the learning function, registera preset code (vpage 157 “Registeringpreset codes”) for a mode other than AVRpreset (vpage 158) to each input sourceswitch button.4 When “KEY” appears on the remote control unit,press the button that you want to store.• You cannot store the remote control code in the ZONE SELECT,RC SETUP, POWER X, FAVORITE STATION 1 – 4, InstaPrevue,SOUND MODE, SLEEP, MACRO A – D and input source selectbutton.5 When “READY” appears on the remote control unit,place the remote control unit of the AV equipmentface to face with main remote control unit (of thisunit). Next, press and hold down the desired button(that you want to store) of the remote control unit ofthe AV equipment.• When the button is correctly stored, “OK” flashes four times onthe remote control unit.• If the button is not correctly stored, “FAIL” flashes four times onthe remote control unit. If this happens, perform step 4 again.6 To store another button, repeat steps 4 and 5.7 When you have finished storing the remote controlcodes, press RC SETUP.“OK” flashes four times on the remote control unit and thenormal operation mode is restored.• There are some remote control units that cannot be programmed,or even if they can be programmed, they may not operate correctly.If this happens, use the remote control unit supplied with the AVequipment to operate it.• The operations of the programmed buttons override the presetmemory. If you do not require the programmed buttons, erasethe stored remote control codes to return to the initial settings(vpage 164 “Erasing stored remote control codes”).• The number of buttons that can be stored varies depending on theremote control unit used. If you have stored the maximum numberof buttons allowed for the remote control unit, “FAIL” appears onits display.