Denon AVR-4520CI Owner's Manual

Also see for AVR-4520CI: Getting started guide Specification Model information Service manual

Contents

38Error messagesNOTE• An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform thenecessary measures. Then perform Audyssey® Setup again.• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speakerconnections and repeat the measurement process from the beginning.• Be sure to turn off the power before checking speaker connections.Examples Error details MeasuresAudyssey SetupRetryCaution! : Please check the cable connection and retry.Microphone or Speaker is None• The connected setup microphone is broken, or a device other than thesupplied setup microphone is connected.• Not all speakers could be detected.• Connect the included setup microphone to the SETUP MIC jack of this unit.• Check the speaker connections.Audyssey SetupRetryCaution!Ambient noise is too high or level is too low• There is too much noise in the room for accurate measurements to bemade.• Speaker or subwoofer sound is too low for accurate measurements to bemade.• Either turn off any device generating noise or move it away.• Perform again when the surroundings are quieter.• Check the speaker installation and the direction in which the speakers arefacing.• Adjust the subwoofer’s volume.Audyssey SetupRetryCaution! : Please check the cable connection and retry.Front R :None• The displayed speaker could not be detected.(The screen on the left indicates that the front right speaker cannot bedetected.)• Check the connections of the displayed speaker.Audyssey SetupRetry Skip ErrorPhase Info.Caution! : Please check the cable connection and retry.Front R :Phase• The displayed speaker is connected with the polarity reversed.(The screen on the left indicates that the polarity phases of the front rightspeakers are reversed.)• Check the polarity of the displayed speaker.• For some speakers, this error message may bedisplayed even if the speaker is properly connected.If you are sure the connection is correct, use o pto select “Skip Error”, then press ENTER.Set up speakers (Audyssey® Setup)