0 About this Manual0.2 Target group6 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.eu0.2 Target groupThis manual is intended for engineers, electricians, and automation techni-cians. Electrical engineering and physics-related knowledge and skills will berequired in order to be able to commission the corresponding devices.In addition, readers must be familiar with how to use the SmartWire-DT sys-tem.0.3 Exclusion of liabilityAll information in this operator manual was provided by us to the best of ourknowledge and belief and in accordance with the current state-of-the-art.However, this does not exclude the possibility of inaccuracies so that wecannot accept any liability for the accuracy and completeness of the informa-tion. In particular, this information does not guarantee any particular proper-ties.The devices described here must only be set up and operated as specified inthis manual and in the installation instructions provided with the device. Thedevices must be installed, commissioned, operated, maintained, and retrofit-ted by qualified people only. The devices must only be used in the recom-mended areas and only in conjunction with third-party devices and compo-nents that have been approved by us. Only use is technically faultlesscondition is permitted. Fault-free and safe operation of the system requiresproper transport, storage, installation and commissioning as well as carefuloperation and maintenance.If the following safety instructions are notobserved, particularly with regard to commissioning and maintenance of thedevices by insufficiently qualified personnel and/or in the event of improperuse of the devices, any hazards caused by the devices cannot be excluded.We assume no liability for any injury or damages incurred.CAUTIONInstallation requires qualified electrician