2 Installation2.1 Setting the gateway's field bus addressSmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.com 17Example:Follow the example below in order to configure an address directly on thegateway - 18 (decimal) is used as an example in this case:18 dec = 16 +2 = 1· 2 4 + 1 · 21The address is to be set at the dip switches.for EU5C-SWD-EIP-MODTCP the following applies:▶ First, use the DIP switches to select the source from which you want toacquire the Ethernet address. For the address setting example in whichthe address is set directly on the device, DIP switch 9 would beswitched to OFF, for instance. The upper three bytes of the IP addressare passed when the project is transferred from the SWD-Assist pro-gram.▶ This way, the last byte of the field bus address can be set to an addressof 18 dec directly on the gateway.Figure 5: Setting the field bus address on an EU5C-SWD-EIP-MODTCP gateway2.1.3 Resetting the Ethernet addressThe gateway can be restored to its default settings at any time. To do this,set DIP switches 1 to 8, as well as the operating mode selector switch (DIPswitch 9), to "OFF" and then power cycle the gateway (turn it off and thenback on).DIP Switch1 2 3 4 5 6 7 8 9 0 Description2 0 21 2 2 23 2 4 25 2 6 27 MODEOFF ON OFF OFF ON OFF OFF OFF OFF X Setting the last byte of thegateway's field busaddress to a value of 18 decEU5C-SWD-EIP-MODTCPExample: Address 18decOFFON 02483264128MODE OFF161OFFOFFOFFOFFOFFOFFDHCPaddressIPONOFFONONOFFOFFOFFOFFOFFBOOTPONOFFOFFOFFONOFFOFFOFFOFFPGMONOFFOFFOFFOFFONOFFOFFOFFPGM-DHCPONOFFOFF987654321OFFON 2 3 4 5 6 7 81 9 0