4 Creating a planned SmartWire-DTSmartWire-DT configuration in SWD-Assist4.5 Set device parameter of the gateway38 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.comAfter the project is transferred to the gateway, the settings and the configu-ration data will be saved in a retentively and will be applied immediately.The way the network settings in the SWD-Assist "Ethernet parameters" tabwill affect the system will depend on how the DIP switches on the devicehave been set.Figure 21: Network settings for field bus communications in SmartWire-DTThe corresponding setting options can be found on → Section “Table 26:Device parameter SWD coordinator”, page 92.4.5 Set device parameter of the gatewayAll "Device information," "Device parameters," etc. tabs refer to the gatewayor to the SmartWire-DT modules. The specific device to which they refer willdepend on the device you clicked on previously on the workspace.▶ On the workspace, click on "EU5C-SWD-EIP-MODTCP."▶ Open the "Device parameters" tab.The program will show the SmartWire-DT coordinator's device parameters.To configure the SmartWire-DT coordinator's device parameters, use the set-tings in the "SWD settings" section. These settings will define the coordina-tor's behavior when the SmartWire-DT modules on the SWD line do notmatch the planned SmartWire-DT configuration in the gateway.→ The DIP switches can be used to restore the default settings atany time (→ Section “2.1.1 Default settings Ethernet address”,page 15).→ Please note that these settings will only take effect if the DIPswitches have been used to set the "Address setting directly onthe device," "PGM," or "PGM-DHCP" address-setting method.