2 Installation2.2 Mounting Considerations18 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.eu2.2 Mounting ConsiderationsInstall the EU5C-SWD-EIP-MODTCP gateway in a control cabinet, a panel-board, or an enclosure in such a way that the power supply and terminal con-nections cannot be touched accidentally during operation. Snap the deviceonto an IEC/EN 60715 top-hat rail or fix it in place using fixing brackets.EU5C-SWD-EIP-MODTCP gateways can be mounted either vertically or hori-zontally.For ease of wiring, leave a clearance of at least 3 cm between the device ter-minals and the wall or adjacent devices.2.2.1 Mounting the EU5C-SWD-EIP-MODTCP gateway on a top-hat railBefore mounting the device, make sure that you have set the device's fieldbus address.Figure 8: Mounting on top-hat rail▶ Place the EU5C-SWD-EIP-MODTCP gateway on the top-hat rail's upperedge in an inclined position. Lightly push the device down and againstthe top-hat rail until it snaps into place over the top-hat rail's lower edge.Figure 6: Vertical mounting Figure 7: Horizontal mounting30 mm(1.18”)30 mm(1.18”)30 mm(1.18”)30 mm(1.18”)1234
