1 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP1.4 Important data for engineering12 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.comFigure 3: The configuration of the terminal sockets at the gatewaya LED yellowb LED greenTable 1: What the various diagnostic LED combinations on Ethernet ports ETH1 and ETH2mean1.4.2 Baud rateThe gateway supports operation with the relevant field bus masters up to thefollowing Baud rate:The unit will adapt to the field bus master's Baud rate automatically.LED Category Status MeaningYellow Link/Activity To Link activeFlashing Ethernet data exchangeoff Link not activeGreen Baud rate To 100 MBit/soff 10 MBit/s→ Even though the DLR protocol (DLR = Device-Level Ring) is notsupported, the device can be used as a non-DLR device inEthernet DLR topologies.. When used this way, the device willcontinuously check whether communication requests are beinghandled via both Ethernet connections. These checks mayresult in increased communications.PIN 1: TPIN 2: TPIN 3: RPIN 4: –PIN 5: –PIN 6: RPIN 7: –PIN 8: –PIN 1: TPIN 2: TPIN 3: RPIN 4: –PIN 5: –PIN 6: RPIN 7: –PIN 8: –①②①②aabbFieldbus Maximum data baud ratein MBit/sEtherNet/IP 10/100Modbus-TCP 10/100