5 Commissioning the PLC programming environment5.1 For Ethernet/IP, using RSLogix 5000 as an exampleSmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.com 435 Commissioning the PLC programming environmentTwo things are required in order to be able to create a PLC application:• Creating the planned SmartWire-DT configuration with the SWD-Assistplanning program, regardless of the protocol that you want to use.• Creating the corresponding user program with the PLC programmingenvironment for the PLC being used.• An example for EtherNet/IP would be the Allen-BradleyRSLogix 5000 PLC programming environment in conjunction with aCompact Logix PLC• An example for Modbus/TCP would be theXSoft-CoDeSys PLC programming environment in conjunction withan Eaton XC20x or XV20x PLC.5.1 For Ethernet/IP, using RSLogix 5000 as an exampleIn order to use the EU5C-SWD-EIP-MODTCP gateway in the RSLogix 5000PLC programming environment, you will have to follow the steps below:1 Configure and set the parameters for the EtherNet/IPEU5C-SWD-EIP-MODTCP module2 Import the SmartWire-DT modules' I/O data (tag list) and use it in theapplication program5.1.1 Selecting the EU5C-SWD-EIP-MODTCP gatewayIn order to be able to use an EU5C-SWC-EIP-MODTCP gateway, you willneed a controller with an EtherNet/IP interface. The PLC programming envi-ronment's "Controller Organizer" pane will show the Ethernet interfacesunder "I/O Configuration."Figure 26: Ethernet interface in the RSLogix 5000 V19.01.00 controller I/O configuration