www.eaton.comNetworkManagement Card(Network-MS)User ManualNetwork Management Card – User Manual 34003991XT_EN/JC Page 119/1437.1 Choice 1: Restart / ResetUse this function to restart the card from the bootThis is equivalent to a restart of the electrical power supply.-----------------------------------------------------------------------------Reset-----------------------------------------------------------------------------1 : Restart the card from the boot0 : Exit-----------------------------------------------------------------------------7.2 Choice 2: Network ConfigurationUse this function to access network settings.-----------------------------------------------------------------------------Network settings-----------------------------------------------------------------------------1 : Read Network settings2 : Modify Network settings3 : Set Ethernet speed0 : Exit-----------------------------------------------------------------------------7.2.1 Choice 1: Read IPv4&IPv6 Network settingsEnables reading of the card's routine settingsNetwork configuration :MAC address : 00:20:85:FD:1C:07Mode : Static IPIP address : xxx.xxx.xxx.xxxSubnet mask : xxx.xxx.xxx.xxxGateway : xxx.xxx.xxx.xxxLink Local IPv6 address : xxxx::xxxx:xxxx:xxxx:xxxx /xxGlobal IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xxGlobal IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx
