www.eaton.comNetworkManagement Card(Network-MS)User ManualNetwork Management Card – User Manual 34003991XT_EN/JC Page 120/1437.2.2 Choice 2: Modify IPv4 Network settingsEnables the modification of network parametersFor each of the following questions, you can press to select thevalueshown in braces, or you can enter a new value.Should this target obtain IP settings from the network?[N]Static IP address [xxx.xxx.xxx.xxx]?Subnet Mask [xxx.xxx.xxx.xxx]?Gateway IP address [xxx.xxx.xxx.xxx]?Wait during your new configuration is saved ...Reset the card to take into account the new configuration.In DHCP mode, the card can receive the following parameters according to the DHCP server settings• IPv4 address• Subnet Mask• IPv4 Gateway address• Primary DNS server• Secondary DNS serverThe card must be restarted in order for the new parameters to be taken into account.7.2.3 Choice 3: Set Ethernet speedEnables the modification of the network speedSet the Ethernet speed : [1 : Automatic, 2 : 10 MBit]1New Ethernet speed : AutomaticWait during the new setting is saved ...Reset the card to take into account the new configuration.The card must be restarted in order for the new parameters to be taken into account.
