Eaton Network-MS User Manual

Also see for Network-MS: Quick start guide

Contents

www.eaton.comNetworkManagement Card(Network-MS)User ManualNetwork Management Card – User Manual 34003991XT_EN/JC Page 43/143For the main outlet ("Master" by default)The first shutdown criteria initiates the restart of the shutdown sequence.• If remaining time is under (0 to 99999 seconds, 180 by default) is the minimum remaining backup timefrom which the shutdown sequence is launched.• If battery capacity is under (0 to 100%); this value cannot be less than that of the UPS and is theminimum remaining battery capacity level from which the shutdown sequence is launched.• Shutdown after (0 to 99999 minutes, not validated by default) is the operating time in minutes left forusers after a switch to backup before starting the shutdown sequence.• Shutdown duration (120 seconds by default) is the time required for complete shutdown of systemswhen a switch to backup time is long enough to trigger the shutdown sequences. It is calculatedautomatically at the maximum of Shutdown duration of subscribed clients but can be modified in theAdvanced mode.• If battery capacity exceeds Minimum battery level to reach before restarting the UPS after utilityrestorationImportant: Certain UPSs do not support this option• Turn off UPS after sequential shutdownOn Disable mode, the card doesn’t send the Shutoff command to the UPS.On Enable mode, the card sends the Shutoff command to the UPS on the shutdown criteria.Important: By default, this option is set to Disable. But if the card detects that an IPP is connected tothe card, then the option goes automatically to Enable, and stays in this state. At this time, only the usercan modify this setting.For the controlled outlets ("group 1 or group 2" by default)The page enables programming of operation time and level in backup mode to manage outlet load shedding inthe event of electric power failure:• Switch Off after (from 0 to 99999, 65535 by default) defines the time during which the outlet is suppliedstarting from the moment of utility failure. Caution, this time includes the outlet shutdown duration.• Switch Off if battery capacity under (0 by default) is an extra condition for outlet shutdown that cantrigger the shutdown sequence before the shutdown duration runs out.• Shutdown duration is the time required for complete shutdown of the systems supplied by the outletwhen an outlet shutdown sequence is launched.It is calculated automatically using the maximum shutdown durations of notified applications on theoutlets.• Switch On after (from 0 to 99999, default 65535) is the period between main output startup and startupof the relevant programmable outlet, therefore outlet startup can be delayed in relation to the mainoutput.Important: Certain UPSs do not support this option