6 Parameters6.5 Parameter descriptionDE1 variable speed starter 09/14 MN040011EN www.eaton.com 1036.5.6.3 Smartwire DTWhen the device is used together with SmartWire-DT, the control terminalscan be configured as shown below by using parameter P-15.P-12 = 9 (SWD control + SWD reference)P-12 = 11 (Local control, SWD reference),enable signal with DI1,external fault message at DI3.Table 28: Configuration with SmartWire-DT and P-12 (= 9, 11)￫ Process data access via SmartWire-DT (P-12 = 9, 10, 11, 12, 13)requires a SmartWire-DT DX-NET-SWD3 module.￫ For more information and technical data on SmartWire-DT andthe DX-NET-SWD3 interface module, please refer to manualMN04012009Z.P-15(Mode)DI1 DI2 DI3 AI1/DI40 ENA n. F. n. F. n. F.1 ENA n. F. EXTFLT n. F.2 ENA n. F. n. F. n. F.3 ENA n. F. EXTFLT n. F.4 ENA n. F. n. F. n. F.5 ENA n. F. EXTFLT n. F.6 ENA n. F. n. F. n. F.7 ENA n. F. EXTFLT n. F.8 ENA n. F. n. F. n. F.9 ENA n. F. EXTFLT n. F.n. F. = no Function.When configured this way, the control terminals “n.F.” will have nofunction whatsoever!
