2-4 Data subject to change without notice 7/07. © 2007 GE DrivesNote: The control circuit common terminals [11], (CM) and are isolated(*1) Use a drive with rated voltage matching the power supply voltage.(*2) Use as required.(*3) Use this peripheral device when necessary.(*4) Remove the jumper wire between P1 and P(+) before connecting a DC REACTOR.(*5) Be sure to use the braking unit (option) when connecting the external braking resistor (option)(*6) Connect the braking unit to P(+) ans N(-). The auxiliary terminals [1] and [2] have polarity.Connect them as shown in the figure above.(*7) The drive can be operated without connecting the auxiliary control power supply.(*8) Terminal (X1) to (X9) can be set to 9 (THR) - Braking unit thermal trip input.(*9) If using V2 or C1, as a reference signal, they must be used exclusively.(*10) It is possible to input voltage signals (0 to +10 VDC or 0 to +5 VDC) to terminals [12] [11] instead of the potentiometer.2.3.1 Basic Connection Diagram (Sink Logic)20 Hp and above Up to 15 Hp
