GE AF-300 P11 User Manual

Contents

5-28This function makes the set frequency jump so that thedrive’s output frequency does not match the mechanicalresonance point of the load.Up to three jump points can be set.This function is ineffective if jump frequencies 1 to 3 areset to 0 Hz.A jump does not occur during acceleration or decelera-tion.If a jump frequency setting range overlaps another range,both ranges are added to determine the actual jump area.C05-C19 Multi-step frequency 1 to 15C 0 5 M U L T I H z – 1C 0 6 M U L T I H z – 2C 0 7 M U L T I H z – 3C 0 8 M U L T I H z – 4C 0 9 M U L T I H z – 5C 1 0 M U L T I H z – 6C 1 1 M U L T I H z – 7C 1 2 M U L T I H z – 8C 1 3 M U L T I H z – 9C 1 4 M U L T I H z 1 0C 1 5 M U L T I H z 1 1C 1 6 M U L T I H z 1 2C 1 7 M U L T I H z 1 3C 1 8 M U L T I H z 1 4C 1 9 M U L T I H z 1 5C01 Jump frequency 1C02 Jump frequency 2C03 Jump frequency 3C04 Jump frequency hysteresisC: Control Functions of FrequencyJump frequency 3➝➝Jump frequency 2➝➝Output frequency(Hz)Jump frequencywidthJump frequencywidthJump frequencywidthJump frequency 1Set frequency (Hz)➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝➝Output Frequency(Hz)FWD-CMSS1-CMSS2-CMSS4-CMSS8-CMONON ON ON ON ON ON ON ONON ON ON ONON ONONC05C13C12C11C10C09C08C07C06C14C15C16C17C18C19➝➝➝➝Jump frequency 2Jump frequency 1Set frequency (Hz)Jump frequencywidth➝➝➝➝➝➝Output frequency(Hz)➝➝➝➝➝➝➝➝Actualjump widthSetting range: 0 to 120 Hz in 1Hz increments (min.)C 0 4 J U M P H Y S T RSetting range: 0 to 30 Hz in 1Hz increments (min.)C 0 1 J U M P H z 1C 0 2 J U M P H z 2C 0 3 J U M P H z 3Setting range: 0 to 120 Hz In 0.01 Hz increments (min.)Multistep frequencies 1 to 15 can be switched by turningterminal functions SS1, SS2, SS4, and SS8 on and off.(See E01 to E09 for terminal function definitions.)OFF is the default value any undefined SS1, SS2, SS4,and SS8 terminals.Related functions: E01 to E09 (Set value: 0 to 3)