Critical PowerModifications reserved Page 108/146GE_UPS_OPM_TLE_SCE_M60_M80_1GB_V020.docx User Manual TLE Series 600 & 800 CE S18.1.3 Restore to normal operation after “System shutdown” with Load not suppliedWARNING !Please check and ensure the conditions of the connected load are safe beforeproceeding, as this procedure will result in the connection of power to the loadcircuit(s).NOTE !Before performing this operation, make sure that the UPS is in the following status: “Q1 - UPS Output switch” MUST BE CLOSED. “External Battery Protections” MUST BE DISCONNECTED.If eBoost™ option is available, make sure that eBoost™ Operation Mode is disabledbefore starting this procedure.View of the Synoptic Diagram after performed thecommand “System shutdown” with LOAD NOTSUPPLIED.1. Restore the command “System shutdown”.Restore the command “System shutdown” through thescreen: Commands 1 / System shutdown / RESET. The Load is supplied by the Mains through the Automatic Bypass. Rectifier starts automatically.LED 1 (Rectifier) blinking, indicates Soft-start. At the end of Rectifier Soft-start the LED 1 (Rectifier) remains lit.The Synoptic Diagram must display the status“LOAD SUPPLIED BY AUTOMATIC BYPASS”.Continue ►
