Critical PowerModifications reserved Page 77/146GE_UPS_OPM_TLE_SCE_M60_M80_1GB_V020.docx User Manual TLE Series 600 & 800 CE S1BATTERY SCREENVoltageThe battery voltage.CurrentThe battery current (negative valuescorrespond to the discharge of thebattery).TemperatureThe temperature of the battery (“XXX”indicates sensor disabled).AutonomyThe estimated backup time with the present Load.Note: the backup time is computed given the unit load.Therefore, during IEMi Operation Mode, on-line units may show a reduced backup time.However, following a power outage, all inverters are forced on-line.Therefore, during battery operation every unit shows the true battery autonomy.Charge levelThe battery charge level.On battery timeTotal operating time of the UPS on battery (in hours).BATTERY DISCHARGE COUNTER / Residual Charge LevelThe number of discharges combined with the percentage of the available residual battery capacity atthe time utility power is restored.Battery charger statusBattery charge status (Off / Float / Boost).RECTIFIER SCREENFrequencyThe input frequency of the Rectifier.Voltage L1 / Voltage L2 / Voltage L33-phase Mains voltage PHASE /NEUTRAL.Voltage DC-link 1DC-Link 1 voltage.Voltage DC-link 2DC-Link 2 voltage.Main failure countTotal number of times a gap of mains in the Rectifier has been reordered.TemperatureRectifier inlet L1 Coil temperature (Normal / Alarm).Temperature a / b / c / da- Temperature of the Rectifier bridge (lower left module).b- Temperature of the Rectifier bridge (upper left module).c- Temperature of the Rectifier bridge (lower right module).d- Temperature of the Rectifier bridge (upper right module – only for 800 kVA).
