3 - 10 S-80 • S-85 • S-80X Part No. 122985Section 3 • Scheduled Maintenance Procedures February 2012CHECKLIST A PROCEDURESA-6Check the High PressureHydraulic Filter ConditionIndicatorNote: Genie specifications require that thisprocedure be performed daily or every 8 hours,whichever comes first.Maintaining the high pressure hydraulic filter ingood condition is essential to good systemperformance and safe machine operation. The filtercondition indicator will show when the hydraulic flowis bypassing a clogged filter. If the filter is notfrequently checked and replaced, impurities willremain in the hydraulic system and causecomponent damage.1 Open the engine side turntable cover.2 Start the engine from the ground controls.3 Change the engine idle to high rpm (rabbitsymbol).4 Visually inspect the filter condition indicator.Result: The filter condition indicator should beoperating with the plunger in the green area.Result: If the indicator displays the plunger inthe red area, this indicates that the hydraulicfilter is being bypassed and the filter should bereplaced. See D-6,Replace the HydraulicFilters.A-7Perform 30 Day ServiceThe 30 day maintenance procedure is a one timesequence of procedures to be performed after thefirst 30 days or 40 hours of usage, whichevercomes first. After this interval, refer to themaintenance tables for continued scheduledmaintenance.1 Perform the following maintenance procedures:• A-10 Grease the Turntable Rotation Bearingand Rotate Gear• B-8 Inspect the Tires, Wheels andLug Nut Torque• B-9 Check the Drive Hub Oil Level andFastener Torque• B-24 Inspect the Boom Extend/RetractCables• D-4 Check the Turnable Rotation BearingBolts• D-7 Replace the Hydraulic Filter Elements
