3 - 22 S-80 • S-85 • S-80X Part No. 122985Section 3 • Scheduled Maintenance Procedures February 2012CHECKLIST B PROCEDURES2 Be sure that all nuts and bolts are tight.3 Inspect all welds for cracks.4 Inspect for exhaust leaks; i.e., carbon builduparound seams and joints.5 Swing the engine pivot plate in towards themachine.6 Install the bolts that were just removed into theoriginal holes to secure the engine pivot plate.Crushing hazard. Failure to installthe bolts into the engine pivot plateto secure it from moving couldresult in death or serious injury.B-5Inspect the Engine Air Filter -Continental, Deutz and PerkinsModelsNote: Genie specifications require that thisprocedure be performed every 250 hours orquarterly, whichever comes first.Maintaining the engine air filter in good condition isessential to good engine performance and servicelife. Failure to perform this procedure can lead topoor engine performance and component damage.Note: Perform this procedure with the engine off.1 Locate the engine air filter assembly.2 Release the latches from the air cleaner canisterend cap. Remove the end cap.3 Remove the filter element.4 Clean the inside of the canister and the end capwith a damp cloth.5 Inspect the air filter element. If needed, blowfrom the inside out using low pressure drycompressed air, or carefully tap out dust.Replace the filter if needed.6 Install the filter element.7 Install the air filter canister end cap and securethe end cap latches.Note: Be sure the discharge valve is pointing downwhen the cap is instaled.
